Adaptateurs

Understanding Thread Standards and Back-Focus

An adapter does two things at once: it changes the connection type, and it changes the distance between your corrector and your sensor. The second effect is the one that causes trouble, because most reducers and flatteners have a back-focus tolerance of about one millimetre.

• M42 (T-thread, 0.75 mm pitch): The long-standing standard for camera adapters. Its clear aperture will vignette sensors larger than APS-C, so full-frame imaging trains should avoid it.
• M48 (2" thread, 0.75 mm pitch): The practical choice for APS-C and full-frame sensors, with enough clear aperture to avoid mechanical vignetting.
• M54 and M68: Larger-diameter threads used by heavier astrographs and larger-format correctors where rigidity and aperture both matter.
• SCT 2"-24 TPI: The rear-cell thread on Schmidt-Cassegrains; requires a specific adapter to reach M42 or M48 for imaging.
• Bayonet adapters: Canon EF and Nikon F adapters place a DSLR or mirrorless body at the correct flange distance, typically 44 mm and 46.5 mm respectively.
• Fine-tuning spacers: 0.5 mm, 1 mm and 2 mm shims that let you land exactly on a corrector's specified spacing rather than near it.

Why Choose David Astro for Adapters

An adapter is a cheap part that determines whether an expensive telescope performs. We treat it that way.

• Free back-focus calculation: Give us your camera, filter thickness, reducer and telescope and we will return a component list with the total spacing worked out.
• Filter thickness accounted for: Glass in the light path shifts focus by roughly one third of its thickness, and we include that in the calculation rather than leaving you to discover it.
• Male and female threads identified: We specify the gender and standard on both ends, which is the detail most listings omit.
• Deep Canadian stock: Hundreds of adapters held domestically, so a missing 10 mm spacer does not cost you three weeks of clear sky.
• Authorized dealer: Genuine manufacturer parts with full warranty, shipped from Canada without duties for Canadian buyers.

Adapters in Canada — Frequently Asked Questions

How do I calculate my back-focus?

Add your camera's sensor-to-flange distance, any filter wheel or off-axis guider, the filter's optical shift, and every spacer between the camera and the corrector. That total must match the corrector's specified figure, usually 55 mm for a standard reducer.

Should I use M42 or M48?

Use M48 for any sensor larger than APS-C. M42 has enough clear aperture for smaller sensors but will mechanically vignette a full-frame chip regardless of the optics ahead of it.

Do filters change my spacing?

Yes. A filter shifts the focal plane by about one third of its glass thickness. A 3 mm filter adds roughly 1 mm to the effective optical path, which is enough to matter at a 55 mm target.

What if I order the wrong adapter?

Contact us with your setup before ordering and we will confirm the parts. That is a faster path than exchanges, and it is a service we provide free.

Send us your imaging train

We will calculate the spacing and specify every adapter you need. Canadian stock, no guesswork.