How do I know if this 115cm EAGLE power cable is compatible with my device?
You must check three things on the device you wish to power. First, confirm it has a 5.5mm outer diameter, 2.1mm inner diameter power input jack. Second, verify it requires 12V DC power with positive tip polarity. Finally, ensure its maximum power consumption is less than 8 amps. This information is usually printed on the device or in its manual.
What is the purpose of the locking screw on this EAGLE power cable?
The locking screw threads onto compatible power jacks to create a secure physical connection that cannot be accidentally unplugged. This prevents power interruptions to critical equipment like your camera or focuser, which can be caused by cable drag as the telescope slews across the sky.
Can I plug this EAGLE power cable into a port other than the 8A one?
No. This cable is designed with a threaded connector that mates specifically with the 8A output ports on an EAGLE unit. It will not physically connect to the lower-amperage, non-threaded ports, ensuring you do not accidentally overload a circuit.
What happens if my device draws more than 8A? Can I still use this EAGLE cable?
You must not use this cable for any device that requires more than 8A of current. Attempting to do so can damage the EAGLE's internal power board, the device itself, or create a fire hazard. Always verify your equipment's power requirements before connecting.
Will this 115cm EAGLE cable be long enough for my SCT setup with a PrimaLuceLab ESATTO focuser?
Yes, at 115cm (approximately 45 inches), this cable is generally sufficient for connecting an ESATTO focuser or other accessories on most common setups, including Schmidt-Cassegrains. It provides enough length to route from an EAGLE mounted on the top of the optical tube down to the focuser at the rear without being too tight at different pointing angles.
My mount uses a 5.5mm/2.5mm plug. Can I use this EAGLE cable to power it?
No. While the outer diameter is the same, this cable has a 2.1mm inner pin. A 2.5mm jack requires a larger pin. Using this cable would result in a loose, unreliable connection or no connection at all. You must use a cable with the correct 2.5mm inner pin for such devices.
